generator

The car's steering hydraulic cone crusher adopts mechanical rack-and pinion type structure, main assembly in before 2005 car, its main characteristic is structure is simple, the operation is flexible and lightweight, shaky and durable. If used properly, can be used to maintain 40,50 million kilometers, some even can offer until vehicle together scrap.
In use and maintenance, we should pay attention to the following, to prolong the using life direction machine
1. In rough pavement road, certainly some pits, slow down the load decreases steering bear.
2. Check the protection on both sides of the direction machine on with universal and direction of the protection of the shaft link state. Sheath damage is causing the steering early wear and damaged most main factor. Sheath damage, water and dust swirl through lesions into steering gear rack, damage internal oil film, leading to grease inside steering rust, abnormal wear appear phenomenon, such as not immediately dispose of internal concrete crusher and sand, in the short term it will cause the abandonment of steering. So at least monthly checks a dustproof sheath state, such as the discovery of sheath is damaged phenomenon must be immediately replaced, and in the replacement of direction before the machine comprehensive examination and maintenance.
3. Doing four-wheel location adjustment before bunch, change steering levers, we must pay special attention to protection after not appear distortion of the phenomenon such as inadequate, assembly, otherwise, it will cause sheath damage.
4. Because of use will gradually become dirty, grease lubrication reduced ability to deteriorate,; Meanwhile the stone crusher will wear increase gradually, particle attrition phenomenon will be more and more heavy, make steering the wear is intensified. About 10 million kilometers per driving to do a comprehensive direction machine maintenance, comprehensive clean, to refill grease.
5. The use of steering the load conditions, and inherit, must use special grease, ordinary grease can not reach the use requirement.
6. Steering in use gap will increase gradually, if the steering wheel or so spare travel more than 15 degrees, must be checked for direction machine, such as rack-and pinion abnormal badly worn, must be replaced direction machine assembly; If there is no abnormal wear, just large clearance, can adjust. In the adjustment to service when by trained professionals, after adjusting to guarantee the steering wheel can hit to right and left, and strength uniform limit position and flexible rotation.
7. Don't random rudimentary facilities, technical level in low roadside store direction machine maintenance and maintenance. Direction jaw crusher such as adjusting undeserved, can cause the jammed phenomenon, endangers and personal safety.